We can test during any season, as long as closed building conditions can be maintained. All external doors, windows, and vents should be kept closed from 12 hours before starting the test until the end of the test. You don’t need to change your normal entry and exit routines, just make sure you close the door behind you. If the building has a permanently installed radon mitigation system, air to air heat exchanger, and/or combustion air supplies for furnaces, etc., they should be operated normally. However, do not operate any whole house or window fans during the test. This test should not be started if severe weather is predicted. For example, a major storm system with winds exceeding 30 miles per hour.
This sampler is designed to be exposed 72 to 168 hours (three to seven days). This means you must leave it in place for at least 3 days. You may expose it up to 7 days if you are not testing in a humid environment (over 55% relative humidity). Either way, your test result will be an average of approximately the last 4 days of the exposure period.
We will test the lowest area of the building that is used on a regular basis. We will place it where it will not be disturbed. The preferred method is to hang the sampler centrally in the room. We will use one sampler for every 2000 square feet of floor space being tested. It should be within the normal breathing zone (2 to 6 feet from the floor). The sampler may be hung from an interior non-masonry wall as long as the opening is not blocked (at least 4 inches clearance) and it is facing toward an open area of the room. String may be useful to hang the kit from the ceiling or light fixture. We will Keep it 3 feet or more from doorways, hallways, windows, exterior walls, and heating or air-conditioning vents. We will not place it in the same room with any type of operating fan or blower. Air blowing on or near an activated charcoal sampler may increase its sensitivity to radon. We will not place it near any heat source such as a stove, fireplace, or baseboard heater. It will be kept out of direct sunlight. Heat may reduce the sensitivity of some radon measurement devices. We will not test areas of high humidity, such as bathrooms, kitchens, laundry rooms, closets, or damp basements.